Pan/Tilt Panoramic Tripod Head
Panoramic tripod heads that allow to pan and tilt around the no-parallax-point use to be
quite expensive. Usually, some kind of (expensive) levelling device is
needed in addition to the pano-head in order to allow panning precisely in
the horizontal plane.
Since I owned a ball-head with a panorama mount anyway, I thought about how
it could be upgraded to be a real pan/tilt/level-panorama head with the
least possible effort. In addition to that, I wanted it to be adjustable to
be able to adapt to different cameras, so it needed to have the mounting
point adjustable in relation to the pivoting axis.
The solution came in form of a special extruded aluminum profile, which a
neighbor of my parents used to construct a milling system (source of supply
http://www.item24.com or http://www.aluprofil.com/ "Profile 5
60x20"). The profile is lightweight and very rugged and it allows for easy
corner joints. One of the grooves in the profile turned out to be able to
accept a slideable tripod mount.
To assemble the pan/tilt-head, I needed to machine an adapter for my ball-
head to be able to mount the head upside down onto the tripod and the
profile onto the panorama-plate of the ball head. This arrangement allows me
to easily level the whole setup and still have a smooth and clearance-free
the whole head
a cheap 2-way-spirit level from a do-it-yourself-store serves as a levelling indicator
the whole head without the camera
the ball-head upside-down
the adapter simply contains a continuous 3/8" screw thread and a slight dent on the top with a slanted edge, so that the camera mounting flange of the ball-head fits metal-on-metal.
the bracket without the macro slide
the slideable tripod mount
I have machined the brass part with the 3/8" tripod screw thread myself. A countersunk screw allows for fixing it in position in the groove. Anybody who has no access to a lathe could perhaps simply screw an adapter shaft (1/4" - 3/8") onto a groove stone with a countersunk screw.
mount for the macro slide (1)
the knob may be replaced by a piece of 1/4" threaded bolt plus a butterfly nut. a metric thread may also be cut into the macro slide mount.
mount for the macro slide (2)
the white disk serves as a spacer, otherwise the thumb wheels of the macro slide would fall foul with the bracket. The spacer is mounted on the bracket/groove with two screws in sliding stones.
the corner joint
The profile allows to screw in thread shafts that can be used to form a corner joint of two pieces of profile using socket head screws. (In this case 4 pieces Item "Automatic-Fastening Set 5, Order no.: 0.0.391.60")
bracket with tilted slide
To be able to adjust for different no-parallax-points, I have provisionally retrofitted a simple scale. The axes for the slide (vertical) and the whole setup (horizontal) have to be in a single plane.
the camera can be tilted to any desired angle
the no-parallax-point is adjusted using the macro slide. In case the optical axis goes through one of the rotating axes, it automatically goes through the othe as well. If the no-parallax-point is adjusted correctly with the slide, both tilting and panning is performed around that no-parallax-point.
© Erik Krause 2002 - 2020 All images on this pages are protected by copyright law. Any use - even pivate - requieres written permission by the author!
e-Mail: Erik Krause
This page does not collect any data
The IP address in the server logs is anonymized.